CB05 | Setup of the CB05 Engine Loading Control Knobs

« CB05 Main Page

For setting up the CB05 for use, follow these steps:

  1. Set the FEED knob pointing left.Pointing at the large dot at the knob’s left. See FIGURE 1 below.
  2. Set the CALIBRATE knob fully clockwise with engine at low idle. See FIGURE 2 below.
  3. Set engine at the ready to grind RPM.
  4. Rotate the CALIBRATE knob clockwise until the tub just begins to turn. See FIGURE 3 below.
  5. Rotate the FEED knob clockwise only until the tub just reaches full, or a lesser maximum tub RPM if a slower maximum tub RPM is desired. See FIGURE 4 below.
  6. Start grinding by loading material to be ground into the grinder.
  7. The FEED knob is now ready to be used to decrease (knob clockwise) and increase (knob counterclockwise) the loading of the engine.
CB05KnobFeedLeft82x81
FIGURE 1
CB05KnobCalibrateCCW78x84
FIGURE 2
CB05KnobCalibrateMid72x80
FIGURE 3
CB05KnobFeedInUse84X81
FIGURE 4